Solid surface sheets can arrive in good condition and still develop handling damage before fabrication starts. Unsupported sheets, dirt trapped between faces and sudden temperature changes can lead to scratches, chips or distortion. A simple receiving and storage routine helps the fabricator identify issues before cutting.
1. Inspect the delivery before signing it off
Check the packaging, sheet count, colour and thickness against the order. Photograph damaged packaging and the affected sheet while labels are visible. Record the batch numbers and note any damage on the delivery documents; follow the carrier and supplier’s claim deadlines. Keep the packaging until the issue is resolved.
2. Support the whole sheet
Store sheets flat on a clean, dry, level and fully supported base. Keep the stack aligned so corners and edges do not project beyond the support. Avoid placing small heavy objects on top: concentrated loads or uneven supports can put stress on a sheet. Follow the manufacturer’s limits for stack height and the load rating of your racks and floor.
Some manufacturers permit purpose-built vertical racks. Use them only when the sheet manufacturer and your safety procedures specify the rack design and restraint. Do not improvise a leaning stack that can tip.
3. Separate, protect and identify
Keep faces clean and prevent grit from being trapped between sheets. Retain protective film where supplied, and use clean protective separators when moving or restacking. Store related sheets together by colour and batch; label offcuts with their colour, lot and dimensions. Check adjacent sheets for colour and pattern compatibility before cutting, especially for a visible joint.
4. Move with a plan
Before lifting, check weight, route, door clearances and the lifting equipment’s capacity. Use trained personnel and appropriate lifting equipment; large sheets may need multiple handlers or a suitable mechanical aid. Protect edges, keep hands clear of pinch points and never drag one finished face over another.
5. Let material reach workshop conditions
Allow sheets and adhesive to acclimate to the workshop before machining or bonding, particularly after cold transport or hot storage. The required temperature and time depend on the actual material, adhesive and manufacturer’s instructions. Avoid using one brand’s processing limits as a universal specification.
What if a sheet appears bowed or damaged?
Do not force it flat and start cutting. Place it on a verified flat, fully supported surface, allow it to acclimate, and document the condition and measurement method. Compare it with the supplier’s agreed flatness and damage criteria. Contact the supplier before alteration: cutting can make the cause harder to assess and may affect a claim.
Quick receiving checklist
- Count, colour, thickness and lot recorded against the order.
- Packaging and sheet faces inspected and photographed where needed.
- Flat, clean support and safe lifting route ready.
- Material and adhesive acclimated under the relevant instructions.
- Any disputed sheet isolated before fabrication.
For the next inspection step, see our solid surface fabrication guide. For an example of manufacturer-specific storage and handling requirements, consult Corian’s handling and storage guidance; always use the instructions applicable to your own sheet.